Designed to replace one or more of the existing weights of the JP Silent Captured Spring, these tungsten weights are heavier than the standard components to allow for more reciprocating mass in the operating system. Specifications for JP Enterprises Gen 2 Tungsten Weight For JPSCS2-15, JPSCS2-10 And JPSCS2-9MM: Manufacturer: JP Enterprises Fabric/Material: Tungsten Cartridge: 9mm Luger Package Contents: JP Enterprises Gen 2 Tungsten Weight For JPSCS2-15, JPSCS2-10 And JPSCS2-9MM
6 reviews for JP Enterprises Gen 2 Tungsten Weight For JPSCS2-15, JPSCS2-10 And JPSCS2-9MM
Only logged in customers who have purchased this product may leave a review.
Related products
$10.99
JP Enterprises
$56.95
JP Enterprises
$132.95
$132.95
$7.99
JP Enterprises
$196.60
JP Enterprises
$59.80
$15.99
TX2A –
This weight is perfect for dialing in your silent capture spring SCS or VMOS bolt carrier. It gives the end user the ability to try out different combinations/ weights for perfect cycling of the system. I can’t really say much more than that. It works for the intended products.
Ellis –
Just what I needed for my gun to run suppressed without being too violent
me –
The JP Enterprises Gen 2 tungsten weight is exactly what I needed to properly tune my silent spring recoil buffer. As is typical with JP Enterprises products the part is flawless and installed just as the supplied instructions stated.
Keith P –
Made the absolute difference for me in timing on my AR-10 chambered in 6.5CM with RLGS+2" barrel using Norma 130gn Golden Target. With SCS H1 with Red/Blue spring and Brownell's Ti BCG it functioned fine but brass was a little dirty with light swipes. Upgrading to a H2 with this buffer weight helped but adding the Red/Green spring timed things perfectly and brass looks like it came out of a gas gun.
Cannon –
These are great for adding weight. Just make sure you know how a snap ring works and are capable of removing it before buying this so as not to look like a moron when you leave a 1 star review on a great product due to simple incompetence
hobbit –
Cant even get the snap ring off my scs to install these. Followed the instructions to a tee, but the snap ring is basically welded on there. Im just going back to a traditional buffer spring and weight. Getting rid of the twang isnt worth this much. Waste of money overall.